Product: Prodac Magic Pump 800
Overview:
A compact and silent operation recirculation pump for fresh and saltwater aquariums.
Pump components:
A - Fully submersible motor unit sealed with a watertight resin.
B - Anti-wear impeller
C - Impeller protection cap
D - Front cover with water inlets and water flow regulator
E - Rear protection cover
F - Outlet fitting
G - Suction cups
Caution:
before performing any type of aquarium maintenance always disconnect the submerged electrical appliances at the mains power supply and check that the voltage on the label affixed to the product corresponds to the voltage of your mains power supply.
Installation:
Insert the suction caps in the recesses provided, position the pump in the purpose compartment, adjust water flow. To reduce water flow move the lever to the left (MIN) and to increase flow move the lever to the right (MAX). The MAGIC PUMP 800 pump has an outlet fitting for connecting either rigid or flexible tubing. To ensure the pump operates and performs correctly, we recommend that the inlets are fully submerged below water level.
Maintenance:
Disconnect all electrical appliances in the aquarium at the mains power supply and remove the pump.To release the front cover from the motor unit use a pointed object and apply pressure on the tab positioned under the pump, remove the impeller protection cap and extract the impeller proceed with rinsing the impeller under warm running water. To reassemble the pump invert the above procedure.
Caution: do not use soap or other types of detergents, if necessary use a toothbrush to remove any stubborn dirt build-up.
Safety regulations:
All electrical appliances used must be connected to an emergency cut-off switch set to 30 mA. Make sure that the mains voltage corresponds to the voltage on the label affixed to the unit. This appliance is intended for indoor use only and is
designed for water temperatures up to 35°C.Do not use this appliance with corrosive or abrasive liquids. Before connecting to the mains supply make sure the cable an the appliance are not damaged in any way. The power cable cannot be replaced or repaired if damaged replace the whole unit. Do not use the appliance for any purpose other than
those described above. Before handling or touching the power cable disconnect from the mains. If the plug or power socket get wet, shut-off the mains before disconnecting the cable. Keep the appliance out of reach of children. To avoid the plug or socket from getting wet due to dripping water, we suggest bending the cable under the level of the power socket (see photo 1) Do not lift the appliance by its cable.
Electrical safety standards for Class II appliances
The Class II pump has a twin cable, double insulation and is not provided with an earthing conductor.
Features:
- Pump head 130cm
- Power consumption 16W.
- Dimension H 7 X L 5,5 X 8 cm
|